Lotus Elise/Exige/211 2006+
Emtron KV8 ECU (sold separately)
Emtron KV Series Mounting Kit (sold separately)
Persuader LE1 Harness Adapter
Bosch wide range Oxygen Sensor
0-100psi Fuel Pressure Sensor
Pavlotech Support Package A (Includes Base Mapping)
NTC Oil Temperature Sensor
Continental Ethanol Sensor (flex fuel)
Traction Sensitivity Knob (early models)
Pavlotech Spec “Persuader” harness adapter retains nearly all OEM functions
All basic EFI systems fully operational (injection, ignition, VVT, etc)
Uses all factory sensors including :
Fuel level input (advanced filtering)
Oil pressure switches (both engine + VVT) - New failure mode conditions
4x processed wheel inputs (Motorsport Traction Function)
Factory traction switch (late model) - Model specific function
Fuel tank pressure
Uses all factory outputs including :
Factory traction LED (late model) - Model specific function
CAN bus wired to OE :
Interface with motorsport dashboard directly from original OBD2 port.
**NO support for factory instrumentation (TBA)
Additional inputs :
Wide band Oxygen Sensor/Lambda Input (Factory oxygen sensors not used)
Fuel pressure input (0-100psi Metri Pack)
Ethanol sensor input (Continental)
Oil temperature input (DTM - NTC)
Traction control switch/knob input (early models - DTM-3 connector - optional)
ECU also has spare I/O that can be wired directly
G-Force sensor (ECU internal) - Traction control
Advanced ECU Functions :
ECU utilizes advanced speed density fuel modeling with flex fuel support to provide consistent and reliable mapping.
Advanced functions for Launch Control, Motorsport Traction Control, Fuel Pressure Differential Compensation, Flex Fuel (0-100% Ethanol), Failure Modes (Pressure/temperature failsafes/Limp), ECU circular logging, and more are included.
See ECU specifications.
Connect to ECU via high speed Ethernet for full calibration available for :
Electronic throttle targeting
Main relay control
Data logging download
Limits (all limiters, limp modes, failure modes, etc)
Engine protection control
Additional ECU functions for Closed Loop Sequential Gearbox Control, Paddle shift, Staged Fuel Injection, and more are available (subsequent to installation/hardware)
Model specific features:
Traction control momentary switch (late model) indicates different modes by flashing the factory LED at different frequencies. This can also be displayed on motorsport dash systems.
Not Supported :
Factory Oxygen Sensors (Kit supplies upgraded Wide Range Lambda sensor)
Factory instrumentation (Not Available - TBA)
OBD2 scan tools/emissions/emissions testing
Factory returnless fuel system
EVAP tank leakage monitoring
Installation Requirements :
This package is designed to be installed with a true rising rate/returnless fuel system. It is not compatible with the factory Lotus returnless fuel system.
ECU must be mounted properly in “right angle” positions in order for the G-Force sensor to be configured properly for Motorsport Traction Control.
Fuel pressure sensor must be located in the feed line to the fuel rail, ON the fuel rail, or as close to fuel rail as possible.
Flex fuel sensor (if used) must be installed.
Oil temp sensor (if used ) must be installed
Traction control position input (early models) must be installed.
Pavlotech tuning solutions are for use on competition vehicles and may never be used on a public road or highway. Customers located outside of the USA need to act within their local laws and regulations. Pavlotech holds no responsibility for any damages that result from the misuse of their products.
Pavlotech tuning solutions offer extreme flexibility regarding engine tuning. The system is not designed for tuning novices. DO NOT attempt the installation of Pavlotech ECU solutions if you are a novice tuner. Potential misuse of these products can destroy precious hardware. Refer to Pavlotech installation manuals (when available) or contact Pavlotech for technical assistance.